Error Displays; Specifications - Clarion CZ102E Manual De Instrucciones Y De Instalación

DISC Player
Problem Cause
Another disc is already loaded.
Disc cannot be
loaded.
There is an object install inside
the unit.
Compact disc is dirty.
Sound skips or is
noisy. Compact disc is heavily scratched
or warped.
Sound is bad Condensation may form on the
when power is first internal lens when the car is
turned on. parked in a humid place.

7. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
Display Cause
Disc is inserted incorrectly.
ERROR 3
The disc format is not supported.
ERROR 5 This is a failure of deck's mechanism. Consult your store of purchase.
If an error display other than the ones described above appears, press the [RESET] button. If
the problem persists, turn off the power and consult your store of purchase.
* When the [RESET] button is pressed, preset radio stations, titles, etc. stored in memory are
kept.
9
CZ102E/CZ102ER/CZ102EG/CZ102EA
Measure
Eject the disc before loading the new
one.
Remove the object inside the unit.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no
scratches.
Let dry for about 1 hour with power on.
Measure
Eject the disc then reload it properly.
Try another disc.

8. SPECIFICATIONS

FM Tuner
Frequency range: 87.5-108.0MHz
Usable sensitivity: 8dBf
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
MW Tuner
Frequency range: 531-1602kHz
Usable sensitivity (S/N=20dB): 34dBμ
LW Tuner
Frequency range: 153-279kHz
Usable sensitivity (S/N=20dB): 34dBμ
CD Player
System: Disc digital audio system
Frequency response: 20Hz-20kHz
Signal/noise ratio: >94dB
Total harmonic distortion: Less than 0.1% (1kHz)
Channel separation: >60dB
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
Joliet file system
Audio Amplifier
Maximum power output:
180W (45W x 4)
Speaker impedance: 4 (4 to 8 allowable)
Input
Audio input sensitivity:
High: 320mV (at 1V output)
Mid: 650mV (at 1V output)
Low: 1.3V (at 1V output)
(input impedance 10 k or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Pre-Amp output voltage:
2.0V (CD play mode: 1kHz, 0dB, 10k load)
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 190mm Depth
Weight of the Main Unit: 1.30kg
Note:
• Specifications and design are subject
to change without notice for further
improvement.