Hama Pulsar 00092473 Manual Del Usuario página 5

g Operating Instruction
The "Pulsar" Bluetooth system is a loudspeaker system for mobile phones based
on Bluetooth technology. Bluetooth technology is a standard for wireless data
communication over a short distance. Compatible components (e.g. hands-free
facilities, loudspeakers etc.) and Bluetooth-enabled mobile phones can establish
a wireless connection and communicate over a distance of up to 10 metres.
The Bluetooth system supports the "A2DP" Bluetooth profi le and can therefore be
used with compatible end devices (mobile phones, PDAs, etc.) for audio playback
via stereo Bluetooth. That means that only end devices that support one of these
two Bluetooth profi les guarantee compatibility with the loudspeaker system.
In addition, the multi-speaker can be used together with Bluetooth for hands-free
operation. The "Headset" and "Handsfree" Bluetooth profi les are supported for
this function.
Extent of delivery
• "Pulsar" Bluetooth system
• 230 V power supply unit
Description
Call/Call-ending button
Volume control button
Charger cable socket
Getting started
Plug in the power supply unit and connect it to the corresponding socket on the
Bluetooth system. The LED on the loudspeaker lights up red during the charging
process. This LED goes out after the charging process has fi nished.
10
00092473bda.indd 10-11 00092473bda.indd 10-11
Speaker
Power/Charger LED
Microphone
Switching the system on/off
Press the call/call-ending button for 2 seconds to switch on the system. The LED
now fl ashes blue. Press the call/call-ending button for 5 seconds to switch off
the system.
Pairing the Bluetooth system with your end device (mobile phone, etc.)
The two components must "get to know" one another before the Bluetooth
system can communicate with your telephone. This process is known as pairing
and is the basis for using the system. Pairing only has to be carried out once,
before the loudspeaker is used for the fi rst time.
Make sure that your end device (mobile phone, PDA, etc.) supports the "A2DP"
Bluetooth profi le. The Bluetooth system cannot be used for music playback if it
does not (see the operating instructions of the device).
Prepare your telephone for the pairing process. Follow the instructions in the
operating instructions of your mobile phone to switch your telephone to Bluetooth
mode and initiate and perform the pairing procedure.
• Make sure that the "Pulsar" Bluetooth system is switched off.
• Press and hold the call/call-ending button for 5 seconds or until the LED begins
to fl ash blue and red alternately and an acoustic signal is heard. Then release
the button. The Bluetooth system is now in pairing mode.
• Start pairing (the search for Bluetooth devices) with your mobile phone as
described in the instructions for your telephone. Follow the instructions on
your telephone's display.
• Your telephone searches for compatible devices in the Bluetooth environment.
• If your telephone has found the "Pulsar" Bluetooth system, this will be
indicated in the telephone's display.
• Follow the remaining instructions on the telephone or in the operating
instructions of the telephone.
• If you are asked for the passkey or PIN, enter "0000".
• Pairing is now complete. The blue LED now fl ashes blue twice every 5 seconds
(standby mode). The Bluetooth system is now ready for use and can be used
with your mobile phone, etc.
11
05.02.2009 13:32:26 Uhr 05.02.2009 13:32:26 Uhr