Hama Pulsar 00092473 Manual Del Usuario página 7

Switch microphone back on (after
muting)
Switch loudspeaker back on (after
muting)
Conference telephony
Please note that this function is generally not supported. This depends on your
provider. If this function is supported, the following features are available:
• Press the call/call-ending and "Volume up" buttons simultaneously to switch
from the waiting call to the active call.
• Press the "Volume up" and "Volume down" buttons simultaneously to change
the priority between the active call and the waiting call.
• Press the call/call-ending and "Volume down" buttons simultaneously to end a
standby call.
TTS mode (Text to Speech)
The "Pulsar" Bluetooth system supports TTS mode (Text to Speech). During an
incoming call, the number of the caller is signalled acoustically, e.g. the hands-
free function of the system "speaks" the number of the caller digit for digit.
To switch to TTS mode, during an incoming call or while in standby mode, press
one of the two volume control buttons briefl y. TTS mode is activated. To
deactivate TTS mode, during an incoming call or while in standby mode, press
one of the two volume control buttons briefl y. TTS mode is deactivated.
Reminder function for missed calls
In the case of a missed call, you will receive a reminder signal every 20 seconds.
If you would like to switch off the reminder function, press the call/call-ending
button or one of the volume control buttons.
14
00092473bda.indd 14-15 00092473bda.indd 14-15
Press the "Volume up" button briefl y.
Press the "Volume down" button
briefl y.
Behaviour mode
You can select either melodic or non-melodic message mode. To select "
melodic", press and hold the "Volume up" button for 3 seconds during an
incoming call. To switch to "non-melodic", press and hold the "Volume down"
button for 3 seconds.
Volume control
You can control the volume of music playback and during hands-free operation
independently using the volume control buttons.
Vibration function
Incoming calls are signalled discreetly by the vibration function. Three
consecutive vibration signals indicate that a connection is unavailable.
Registration and safety certifi cation/general information
This device bears the CE marking as specifi ed by the provisions of Directive
R&TTE (1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with the
basic requirements and other relevant guidelines and regulations of the 1999/5/EC
guideline. You will fi nd the declaration of conformity in the Internet at
http://www.hama.com.
15
05.02.2009 13:32:26 Uhr 05.02.2009 13:32:26 Uhr