Using The Conductivity Meter; Fitting The Batteries - Elcometer 138 Guia Del Usuario

4 USING THE CONDUCTIVITY METER

4.1 OVERVIEW
1 Battery Compartment Lid
2 LCD Display
3 Controls (see Section 4.3 on page en-6)
4 Sensor Cell / Electrode

4.2 FITTING THE BATTERIES

The Elcometer 138E Conductivity Meter uses dry cell batteries only.
Four 1.5V LR44 alkaline batteries are supplied in the kit.
To fit the batteries:
1 Unscrew the battery compartment lid.
2 Place batteries in battery compartment
ensuring correct polarity (Figure 1).
Remove old batteries by pulling the plastic ribbon
(Figure 1).
The battery condition is indicated by a symbol on
the display:
Note: Batteries must be disposed of carefully to avoid environmental contamination.
Please consult your local Environmental Authority for information on disposal in
your region. Do not dispose of any batteries in fire.
en-5
R
3 bars indicates the battery is full (100%).
2 bars indicates 50% of the battery life is left.
1 bar indicates 25% of the battery life is left.
Blinking battery casing indicates the need to replace
batteries with new ones.
2
3
4
Plastic
+
Ribbon
-
Figure 1
www.elcometer.com
1