Uline QUIKDOT PRO H-8709 Guia De Inicio Rapido

H-8709
QUIKDOT™ PRO DISPENSER
AND ROLLS
1. Remove the protective nose cover and set it aside.
(See Figure 1)
Figure 1
Plastic Nose Cover
2. Press the locking tab and open the clear cover.
(See Figure 2)
Figure 2
Press Down
3. With the leading edge of the liner pulled clockwise,
place the adhesive roll on the spindle and turn so it
falls into place. The leading edge of the liner will not
have adhesive on it to make threading easier.
(See Figure 3)
4. Pull the liner under the blue roller and over the clear
post. Hold the adhesive roll with one hand while
pulling the liner tightly over the top of the roll with
the other hand. (See Figure 3)
PAGE 1 OF 3
1-800-295-5510
uline.com
LOADING INSTRUCTIONS
5. While keeping tension on the adhesive roll, form
a "U" shape with the liner and insert the curve of
the "U" into the slots on either side of the tab on the
rewind spool, leaving about an inch of liner through
the second slot. Ensure liner is taut as it is inserted
through the slots. (See Figure 3)
6. Fold the excess liner back over the tab, and then
wind the rewind spool clockwise while keeping
tension on the adhesive roll. (See Figure 4)
7. Remove tension on adhesive roll. Make two full
revolutions of the rewind spool to secure the liner in
place.
8. Close the clear cover of the QuikDot™ Pro until the
locking tab is secured.
Pour le français, consulter la page 3.
Rewind
Spool
Spindle
Clear Post
Figure 3
Figure 4
Para Español, vea página 2.
Blue Roller
Excess Liner
Rewind
Spool
0421 IH-8709