A
B
9
9. Pos A (2x):
- Fig 9A: Position the fork of the tool around the
pocket. Make sure the tip of the fork is between
the seat and the base plate.
- Fig 9B: Gently push/slide the tool downward
between both parts until the clicker unlocks.
11
11. Pos F (2x):
- Position the tool with the tip of the fork
between the seat and the base plate
(at approximately 5cm/2" from the front
corner of the seat).
- Press the tool gently between the seat
and the base plate to unlock the clicker.
13
M A N U A L
13. Pull the frame of the backrest
and the chair legs off the seat.
The armrests can not be detached
and replaced.
A
10
10. Pos B-E (2x);
- Fig 10A: Place the wedge end in the pocket by sliding
along the back of the pocket. Tip of the wedge end touches
the tip of the clicker. Tool and base plate are angled.
- Fig 10B: Press down the tool toward the base plate, while
lifting the base plate, until the clicker unlocks.
12
12. Pull the base plate upward over the chair
legs. Keep the base plate horizontal while
pulling.
B
English
11