LaserLiner AutoCross-Laser 2 Plus Manual De Instrucciones página 11

Checking the vertical line:
Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m length on the wall, making
sure that the bob can swing freely. Switch on the device and align the vertical laser to the plumb line. The
precision is within the specified tolerance if the deviation between the laser line and the plumb line is not
greater than ± 1.5 mm.
Checking the horizontal line:
Position the device about 5 m from a wall and switch on the cross laser. Mark
point B on the wall. Turn the laser cross approx. 2.5 m to the right and mark
point C. Check whether the horizontal line from point C is level with point B
to within ± 2 mm. Repeat the process by turning the laser to the left.
!
Regularly check the adjustment before use, after transport and after extended periods of storage.
Technical data
(Subject to technical alterations 11.13)
Self-levelling range
Precision
Laser wavelength
Laser class
Power supply
Operating time
Operating temperature
Storage temperature
Protection class
Weight (incl. batteries)
Dimensions (W x H x D)
EU directives and disposal
This device complies with all necessary standards for the free movement
of goods within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: www.laserliner.com/info
AutoCross-Laser 2 Plus
± 3°
± 2 mm / 10 m
635 nm
2M / < 5 mW
3 x 1.5V alkaline batteries
approx. 20 h
0°C ... + 50°C
-10°C ... + 70°C
IP 54
0,5 kg
115 x 95 x 65 mm
2,5 m
B
C
11
GB