General Safety Instructions; Special Product Features - LaserLiner AutoCross-Laser 2 Plus Manual De Instrucciones

!
Read the operating instructions and the enclosed brochure „Guarantee and additional notices"
completely. Follow the instructions they contain. Safely keep these documents for future reference.
Function / Application
Cross-line laser vertical and horizontal alignment
– The slope-mode feature is an extra that permits gradients to be laid out.
– Individually switchable laser lines
– Out-Of-Level: Is indicated by optical and acoustic signals
when the unit is outside its self-levelling range.
– The unit's two magnetic wall brackets allow it to be used as a stand-alone device
or in combination with others - on the wall or attached to magnetic objects.
– Ideal for mounting on drywall construction profiles
– Automatic levelling range 3°, accuracy 2 mm / 10 m

General safety instructions

Caution: Do not look directly into the beam. Lasers must be kept out of reach of children. Never
intentionally aim the device at people. This is a quality laser measuring device and is 100% factory
adjusted within the stated tolerance. For reasons of product liability, we must also draw your attention
to the following: Regularly check the calibration before use, after transport and after extended periods
of storage. We also wish to point out that absolute calibration is only possible in a specialist workshop.
Calibration by yourself is only approximate and the accuracy of the calibration will depend on the care
with which you proceed.

Special product features

Automatic alignment of the device with a magnetically dampened pendulum system.
The device is brought into initial position and aligns itself autonomously.
Transport LOCK: The device is protected with a pendelum lock during transport.
Special high performance laser diodes generate even brighter laser lines as units with
PowerBright Technology do. They remain visible over longer distances, in bright ambient
lighting conditions and on dark surfaces.
RX-READY technology enables line lasers to be used even in unfavourable light conditions.
The laser lines pulsate at a high frequency and this can be picked up by special laser
receiversover long distances.
Laser radiation!
Do not stare into the beam
or observe it directly with
optical instruments.
Class 2M laser
< 5 mW · 635 nm
EN 60825-1:2007-10
AutoCross-Laser 2 Plus
07
GB