Tabla de contenido
Publicidad
3. System Requirements and installation
The GN 8120 USB requires the following operating systems and an available USB port.
Vista
•
• Windows XP (Home and Pro.)
• Windows Me (millenniumEdition)
• Windows 2000
• Macintosh OS 9.0.4 (or greater)
The GN 8120 USB does not work with earlier releases of these operating systems.
Windows XP, Windows 200 and Macintosh OS 9.0.4 (or greater) operating systems:
With the Windows XP, Windows 200 and Macintosh OS 9.0.4 (or greater) oprating systems, you
are ready to use your GN 8120 USB and require no software installation. Simply plug the USB
connerctor into any USB port on the computer.
Plug the USB connector into an available USB port on the computer, the visual indicator on the
base will light green. The first time windows detects that the device is connected, it recognizes
that there is new hardware required and automatically launches the Add New Hardware Wizard.
Windows Me:
The Add New Hardware Wizard wil launch one (1) time, installing the following driver:
• USB Audio Device (INF\WDMA_USB.INF).
3.1 Installing software: for Windows Me operating systems only
Plug the USB connector from into an available USB port on the computer.
The first time Windows detects that the device is connected, it recognizes that there is new
hardware required and automatically launches the Add New Hardware Wizard.
Add New Hardware Wizard ( ) - USB Composite Device (Windows 98 SE Installation)
1.
Next, the wizard automatically installs the USB Audio Device. The Add New Hardware Wizard
indicates that it has found the new USB Composite Device. Click Next.
2.
The Wizard prompts you to search for the best driver for your device or select the
driver you want from a displayed list ( ). Select Search for the best driver for your
device. Click Next.
3
Windows now searches for new drivers in a specific location ( ). Uncheck all the
boxes. Click Next.
4.
The Wizard indicates that it is ready to install the best driver for this device ( ).
Click Next to install the driver.
5.
Click Finish when the Wizard is complete.
If the Wizard Cannot Locate the Driver
If the Add New Hardware Wizard cannot locate the driver, insert your Windows
Operating System CD-ROM into the CDROM drive. Once inserted, press Back, and check
the box for your CD-ROM drive (usually D). Click Next. Click Finish when the Wizard is
complete.
Note: Do not unplug the USB connector from the computer while an application that
uses USB audio is running. This could cause a system crash.
4
4. Charging The Headset
During charging of your headset please make sure your PC remains switched ON
4.1
4.2
3 sec
1) If you have purchased an external power adapter ( see sec. ll) then your PC does not need to be switched
on while charging of the headset
1)
4.1 Place headset in charge
cradle and charge a minimum of
30 min. before use. A full charge
takes about 2 hours. Visual
indicator on headset will flash
green while headset is charging,
and light steady green when fully
charged.
4.2 Turn on headset by pressing
answer/end button for 3 sec.
(visual indicator will light green
for 2 sec. and two "beeps" will be
heard), or by placing headset in
charge cradle. Turn off headset by
pressing answer/end button for 3
sec. (visual indicator will light red
for 2 sec. and two "beeps" will be
heard).
5
Publicidad
Tabla de contenido
