Monitor Installation - ZALMAN TM270VA LED Manual Del Usuario

2. Monitor Installation

1. Connect Signal Cable
Connect the signal cable connector to D-Sub, HDMI port and fasten two bolts
firmly for grounding.
2. Connect Power Cable
Connect one end of the power cord to AC adapter and the other to the wall outlet or
multiple outlets. Then connect the DC cable of the AC adapter to the power
connector of the monitor.
3. Turn on the Monitor
Turn on the monitor and computer.
When you turn on the monitor, green or light green LED will be on. If LED is red or
flickering, check the connection of video signal cable. If LED is off, press the ' '
button gently.
4. Cautions in Installation
1. Install in the stable place.
2. Install where there is no moisture or dust.
3. Avoid the place exposed to direct sunlight or heating appliances.
4. Do not block the ventilation holes.
5. Avoid objects with strong magnetic forces.
3. Notice
■ This monitor complies with international VESA DPMS standard.
■ This monitor obtained the electromagnetic compatibility certificate for home use,
and therefore it can be used in all type of areas including the residential area.
■ Due to the characteristic of the LED panel, the brightness on the top and bottom
of the screen can be more or less different due to the difference in the viewing angle.
■ Due to the characteristic of the LED panel, viewing the same image for a long time
can cause image retention which will disappear over time.
The optimum resolution is 1920 × 1080.
■ When you use this monitor for the first time, if you are not satisfied with the screen,
you can change settings through the menu.
■ VESA hole is on the back of the monitor. (100 × 100mm)
■ Use the adapter provided with the monitor to supply power to the monitor.
Using other adapters can cause trouble and is not covered by the warranty for
free repair service.
■ This monitor can generate noise with few VGA card or at a specific frequency.
When the noise is generated, adjust manually.
WWW.ZALMAN.COM
5