Lorell LLR25959 Instrucciones De Instalación página 12

Operation Guide Operation Guide
1.1 Upward and downward movement
Press and hold
or
to the desired height. The display will appear the real height.
1.2 Memory mode
Press until H1 appears; release the button, the desk moves to corresponding
until H1 appears; release the button, the desk moves to corresponding
height and displays current height.
Press until H2 appears; release the button, the desk moves to corresponding
until H2 appears; release the button, the desk moves to corresponding
height and displays current height.
Press until H3 appears; release the button, the desk moves to corresponding
until H3 appears; release the button, the desk moves to corresponding
height and displays current height.
Press until H4 appears; release the button, the desk moves to corresponding
until H4 appears; release the button, the desk moves to corresponding
height and displays current height.
1.3 Power-saving Mode
When no actions for approximately 3 minutes, the control panel will enter
power-saving mode. Touch any button to enter operation mode.
1.4 Memory height setting
To store a certain height, first press
the display and then press
memory. Each number can store a different height. You can recall any of the
four heights settings by pressing the corresponding buttons. When no actions
after the display flashes for 6 seconds, the setting will be canceled.
1.5 Reset
Long press
for 5 seconds, display
downward to the lowest height and rebound certain height. The reset is
finished and show basic height.
1.6 Conversation between metric and British system
Press button with 3 seconds, and the screen shows and flickers; Press
M
button with 3 seconds, and the screen shows and flickers; Press
M
M button again and functionality will be shown. Use
which will show the preset height data.
between opitons
(
current option.
or , control the desk upward or downward movement
, control the desk upward or downward movement
M
within 6 seconds to store current height in
for 5 seconds, display
、
、 (
). Press "M" button and keep 2 seconds to save
M the current height position will flash on
the current height position will flash on
within 6 seconds to store current height in
and release, the unit will move
and release, the unit will move
Press
Press M button.
). Press "M" button and keep 2 seconds to save
and switch to（
and switch to（
M button.
Use
Use to switch
）
）
to switch