EGO ST1500E-F Traducción De Las Instrucciones Originales página 15

PROBLEM
Trimmer head will not
advance line
Grass wraps around
trimmer head and
motor housing
The blade is not cutting
the line.
Cracks on the trimmer
head or the lower cover
assembly comes loose
with spool base.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
CAUSE
◾
The motor shaft or trimmer head
is bound with grass.
◾
There is not enough line in the
trimmer head.
◾
The trimmer head is dirty.
◾
Line is tangled in the trimmer
head.
◾
The line is too short.
◾
Cutting tall grass at ground
level.
◾
The line-cutting blade on the
edge of the guard has become
dull.
◾
The trimmer head is worn out.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1500E-F
SOLUTION
◾
Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
◾
Remove the battery and replace the cutting
line; follow the section "LINE REPLACEMENT"
in this manual.
◾
Remove the battery and clean the lower cover
assembly, spool and upper cover.
◾
Remove the battery, remove the line from the
spool and rewind; follow the section "LINE
REPLACEMENT" in this manual.
◾
Remove the battery and pull the lines while
alternately pressing down on and releasing the
trimmer head.
◾
Cut tall grass from the top down, removing
no more than 20cm in each pass to prevent
wrapping.
◾
Sharpen the line-cutting blade with a file or
replace it with a new blade.
◾
Replace the trimmer head Immediately
performed by a qualified service technician.
EN
15