Introduction; Product Features; Use; Assembling The Juicer - Cuisinart CCJ200E Instrucciones

1. INTRODUCTION

You have just purchased a Cuisinart® juicer.

. PRODUCT FEATURES

1. Lid
. Juicing cone
3. Sieve
4. Container
5. Spout with anti-drip system
6. Release mechanism
7. Motor base
8. Cord winder (not shown)
6

3. USE

A. ASSEMBLING THE JUICER
• Rinse the lid, the juicing cone, the sieve and the container in
warm water. Do not rinse the motor base in water but simply
wipe it using a damp cloth.
• Fit the container onto the motor base. The three plastic notches
1
located on the bottom of the container are inserted into the

three holes located on top of the motor base.
• Position the juicing cone on the top of the release mechanism.
3
• Place the lid on the container.
• Plug the unit in. The juicer is ready to be used.
4
B. USING THE JUICER
5
• Place the unit on a horizontal, level surface.
6
• Remove the lid.
• Place a glass or other container under the spout.
• Set the spout to the open position.
7
• Cut the fruit horizontally.
8 • Place the centre of the fruit on the centre of the juicer. Place
your palm on the fruit.
• Press the fruit down firmly enough to activate the release
mechanism.
• When you feel the juicing cone through the skin of the fruit,
remove the fruit.
• Take another piece of fruit and repeat.
• After juicing approximately 00 gr of fruit (the equivalent of 3
oranges), the sieve will appear to be full.
• Remove the fruit from the juicing cone and place the lid on the
juicer. Press down on the cover to activate the 'fast spin' . This
will release any juice remaining in the sieve.
• Once the juice stops flowing, release the lid. The 'fast spin' func-
tion will stop.
• Turn the drip spout to the closed position and remove the glass
or container from under the spout.
• Remove the lid and the juicing cone and empty the pulp from
the sieve.
• Rinse the juicing cone and repeat the above steps as often as
required until you have the desired amount of juice.