Other Information; Troubleshooting - Black and Decker BDH1800S Manual De Instrucciones

nOTE:
The cleaner the filter is, the better the product will perform.
• The dust bowl can also be washed in warm soapy water as shown in figure H.
Ensure that it is dry before re-attaching.
Never immerse the product in water. A damp cloth and soapy water should be used
•
to clean the exterior of the motor section. Always ensure the product is completely dry
before re-use or storing.
RUn TIME
• When fully charged, the average effective usage times are between 10-15 minutes.
• It may take several chargings before these times can be achieved.

OTHER InfORMaTIOn

If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
aCCESSORIES
The performance of your appliance depends on the accessory used. Black & Decker
accessories are engineered to high quality standards and are designed to enhance the
performance of your appliance.
• Filter accessory number VF200SP.
Problem
• Unit will not start.
• Battery will not charge. • Battery not inserted into charger.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MaInTEnanCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the
vac; never immerse any part of the vac into a liquid.
nOTE:
Make sure the vacuum is completely dry before using it.
IMPORTanT:
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service organizations, always using identical replacement parts.
THE RBRC™ SEaL
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the costs
to recycle the battery (or battery pack) at the end of its useful life have
already been paid by Black & Decker. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste stream and the
RBRC program provides an environmentally conscious alternative. RBRC in

TROUBLESHOOTInG

• Battery not installed properly.
• Battery not charged.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
To assure product SAFETY and RELIABILITY, repairs, maintenance and
Possible Cause
7
• Check battery installation.
• Check battery charging
requirements.
• Insert battery into charger
until green LED appears.
• Plug charger into a working
outlet. Refer to "Important
Charging Notes" for more
details.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle is
connected to a light switch
which turns power off when
you turn out the lights.
• Move charger and tool to a
surrounding air temperature
of above 40 degree F(4,5°C)
or below 105 degree F
(+40,5°C).
Possible Solution