Package Contents; Electrical Safety - DeWalt DCS350 Traducción De Las Instrucciones Originales

Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge D WALT battery packs only with
e
designated D WALT chargers. Charging
e
battery packs other than the designated
D WALT batteries with a D
e
charger may make them burst or lead to
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Rod cutter
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (Fig. 1)
A. Trigger switch
B. Reset/lock-off button
C. Stationary cutting die
D. Moving cutting die
E. Hex wrench
F. Hang hook
G. Battery pack
H. Battery release button
I LED worklight
J. Cutting die cap screws
INTENDED USE
The threaded rod cutter is intended for cutting
applications.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This rod cutter is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
DO NOT use for cutting tempered bolts, threads of
different sizes, or reinforcing rod.
WALT
e
Mild Steel
Stainless Steel

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
RECOMMENDED APPLICATIONS
Rod Size
M6 x 1
M8 x 1.25
M10 x 1.5
M12 x 1.75
M6 x 1
M8 x 1.25
M10 x 1.5
english
37