ZIGBEE Q-Control 7202-21 Manual De Instrucciones página 31

Q-Control_Fernbedienungsanl_8.indd 31
5. Programme light/device to
remote control system
Switch on light/device to be paired. Switch off all
other ZigBee compatible lights/devices. Now move
the Q remote control right up close to the light/device
to be paired (≤10 cm distance from the antenna) and
hold down one of the group keys (1 | to | 6) until the
status LED flashes four times for a second at a time
and then three times briefly in succession (please do
not interrupt this process). Then let go of the group
key.
Status LED
fl ashes
1 sec. 2 secs.
As a response from the light/device there are three
brief flashes and then after 1-3 seconds a single flash.
The light/device has now been successfully paired.
If the light fails to flash once more, the link has not
been established. Please repeat the process or see
guidance at point 12.
A light/device can simultaneously be assigned to up
to 6 groups. To do this, repeat the process using the
relevant groups keys, as described above.
3 secs. 4 secs.
GB
5 secs.
31
27.03.17 11:31