ZIGBEE Q-Control 7202-21 Manual De Instrucciones página 38

10. Reset the
Switch on Q-RC. Press ‚On' key so that the status LED
flashes once. If the status LED fails to flash, please
charge the battery.
Then push a straightened paper clip into the reset
opening (hole) on the bottom of the remote control unit
and hold it pressed in for more than 5 seconds. Status
LED flashes five times, then ten times in succession.
1 sec.
Then
The remote control unit has now been reset to the
factory settings.
38
Q-Control_Fernbedienungsanl_8.indd 38
factory settings
2 secs.
Remote control
Off/On
RC to
®
3 secs. 4 secs.
Reset
ON
‚On' key
5 secs.
Reset
27.03.17 11:31