Troubleshooting - Ryobi p2002 Manual Del Operador

pRoblEM
String will not advance when using
the auto-feed head:
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed.

TRoUblEshooTINg

possIblE CAUsE
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
CALL US FIRST
For any questions about operating or maintaining your product,
call the Ryobi
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
10 — English
solUTIoN
Lubricate with silicone spray.
Install more string. Refer to string Replacement
earlier in this manual.
Pull string while pressing button.
Remove string from spool and rewind. Refer to
string Replacement earlier in this manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latches on each side of the battery pack snap
into place.
Charge the battery pack according to the
instructions included with your model.
Help Line!
®