Using The Remote Control; Replacing The Battery - Toshiba SB1 Manual Del Usuario

The sound bar will automatically go to the standby mode in 10 minutes if
NOTE
no audio output.

Using the remote control

Remove the plastic sheet before operating the remote control for the first time.
(Sample Illustration) Remove the plastic sheet before operating the remote
control
While using the remote control, please follow the instructions below:
Point the remote control at the remote sensor and press the buttons.
■
Distance: Approximately 5m from the front of the remote sensor.
■
Angle: About 30° in each direction from the front of the remote sensor.
■

Replacing the battery

The remote control is provided with one CR2025 (3V) battery. To replace
the battery, please follow the instructions below.
1. Open the battery door.
(Sample Illustration) Open the battery door
User's Manual
3D SOUND BAR SB1
EN-9