Denon DCD-F101 Instrucciones De Operación página 14

ENGLISH
(4) Editing functions (when connected to the DRA-F101 and DRR-F101)
Use this function to automatically edit the tracks on the CD to fit on the tape to be used for recording.
2
The editing function is set from system remote control unit (RC-927) included with the receiver (DRA-F101).
2
Example: Recording a disc containing 18 tracks with a playing time of 56 minutes onto a 60-minute cassette tape
MEMORY TUNING
SOURCE
FUNCTION TONE TIMER RDS / SET DOWN UP BAND DIRECT
SYSTEM
ON / STANDBY
PHONES
1
DRA-F101 (receiver)
2
2
ON / STANDBY
TRACK
DCD-F101
3 3
e
ON / STANDBY
DOLBY NR
CD SRS REC 0 PLAY 1
ON
OFF
DRR-F101 (Cassette deck)
OFF ON
1
SYSTEM
POWER
PROG /
DIRECT
1 2 3
CALL
4 5 6
CLEAR
7 8 9
RANDOM REPEAT
10 +10
CD SRS
TAPE MD TIME EDIT
4
TIME/
DIMMER
PANEL
5
RDS BAND TUNING
6
STOP PLAY VOLUME
/SELECT
PRESET
+
RC-927 (system remote control unit)
14
Turn on the power of the receiver.
VOLUME
The system's power turns on.
SYSTEM
ON / STANDBY
1
AM-FM STEREO RECEIVER DRA-F101
(DRA-F101)
6
Load the CD, then close the
2
disc holder.
REPEAT
Load the cassette tape onto
COMPACT DISC PLAYER DCD-F101
which you want to record into
3
the cassette deck, then close
the cassette holder.
Set the function select switch
to "CD" position.
PLAY
Press the edit button and select
the length of the tape.
CD SRS REC
REVERSE
MODE
CASSETTE DECK DRR-F101
• For example, when using a 60-minute (C-60)
tape, press the edit button (EDIT) four times.
(The tape length is the total length of sides A
and B.)
The display switches as follows each time
4
the edit button (EDIT) is pressed:
d
• Approximately 3 seconds after the tape length
is set, the remaining time on side A or B of
the tape appears by turns.
Press the time button.
• The remaining time on side B
of the tape appears.
• The display
between sides A and B each
5
time the button is pressed.
(Use this to check the
remaining time for side B).
ON
SYSTEM
POWER
(RC-927)
(DCD-F101)
5
NOTES:
• The editing function will not work with discs containing more than 21 tracks.
• Load the cassette tape onto which you want to record into the cassette deck's cassette tray with side A facing up
(DRR-F101)
before starting edited recording. The beginning of the tape is automatically found before recording starts.
• When using a recorded cassette tape for edited recording, recording stops and a blank section is left on side B of
the tape if the tape is longer than the set time, so erase the tape beforehand.
TIME EDIT
• When the editing function is used for recording, the reverse mode is automatically set to
cassette deck's reverse mode switch is set to
completed.
(RC-927)
• In some cases it may not be possible to record all the tracks on the disc, even if the tape is longer than the disc's
recorded time (because of how the tracks are divided onto sides A and B of the tape). The "OVER" indicator
flashes if there are tracks that cannot be recorded.
• Only the stop button (
during editing.
• When recording using the editing function, the auto space function is activated and blank spaces of approximately
4 seconds are automatically created between tracks. Because of this, when recording CDs containing for example
recordings of concerts without spaces between tracks, blank spaces will be created in the middle of the piece. In
this case, do not record using the editing function.
(5) CD synchronized recording (when connected to the D-F101 series)
This function allows easy recording of CDs.
2
This function allows easy recording from CD to MD, from CD to Tape.
2
Refer to the respective operating instruction of each model.
(6) Timer functions (when connected to the DRA-F101)
The timer functions of the receiver (DRA-F101) can be used to play CDs at set times.
2
• Refer to the operating instruction included with the DRA-F101.
Press the play button on the DCD-F101.
• Playback on the DCD-F101 and recording on
the cassette tape start simultaneously.
TIME/
PANEL
switches
6
(RC-927)
• To cancel the editing mode, press the stop button
( ) on the DCD-F101 or the cassette deck to stop
2
playback of the CD.
The editing mode is not canceled if other buttons
are pressed.
, and recording continues on side B after recording on side A is
), time mode button (TIME) and power buttons (ON/STANDBY or POWER) will function
2
1 3 PLAY
(Main unit) (RC-927)
even if the