Husqvarna CR 125 2011 Manual Del Usuario página 63

DIGITAL INSTRUMENT, WARNING LIGHTS (WR)
The motorcycle is equipped with a digital instrument; on the
instrument are located 2 warning lights too: high beam and
blinkers.
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "BLINKERS"
The instrument display illuminates (amber colour) when the
engine started.
NOTES
- Every time the engine starts, for the first 2 seconds, the
instrument shows the version of the checking SW; after the
check, the instrument shows the last planned function.
- When the motorcycle engine is OFF, the instrument doesn't
also show its functions.
- To select the instrument functions and to set to zero the
functions, use the SCROLL knob (A).
- The instrument functions are the following, as shown below.
1- SPEED / ODO (figure 1)
2- SPEED / CLOCK (figure 2)
3- SPEED / TRIP (figure 3)
4- SPEED / CHRONO (figure 4)
1- SPEED / ODO (figure 1)
.................
1- SPEED (Km/h or mph) / ODO (figure 1)
- SPEED: motorcycle speed- maximum value: 299 Km/h or 299
mph;
- ODO: odometer- maximum value: 99999 km;
To replace kilometers with miles or miles with kilometers pro-
ceed as follows:
1) set to figure 1, stop the engine and push the knob SCROLL
(A);
2) Start the engine holding pushed the button SCROLL (A) until
the symbol "Km/h" will be displayed;
3) then the symbols "Km/h" and "Mph Miles" will be displayed
alternatively. Push again the SCROLL (A) button when the
unit you wish to use is displayed.
11