Husqvarna CR 125 2011 Manual Del Usuario página 93

PADS CLEANING
Be careful that no disc brake fluid or any oil gets on brake pads
or discs. Clean off any fluid or oil that inadverently gets on the
pads or disc with alcohol.
Replace the pads with new ones if they cannot be cleaned sat-
isfactorily.
PADS INSTALLATION
- Install new brake pads.
- Reassemble the two pins (2) and the springs (1).
1
WARNING!
Do not attempt to ride the motorcycle until
the brake lever or pedal are
fully effective. Pump the brake
lever or pedal until the pads are against the
discs.
The brake will not function on the first ap-
plication of the lever or pedal.
FRONT
2
2
REAR
1
41