Hotpoint Ariston LI 480 A Manual De Instrucciones página 15

Ocultar thumbs Ver también para LI 480 A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
Connect the outlet hose (without bending it) to a drain duct
with a minimum diameter of 4 cm. Alternatively, rest it over a
sink or tub; the free end of the hose should not remain
immersed in water.
A
We advise against the use of hose extensions.
Before inserting the plug into the electrical socket, make sure
that:
the socket is earthed and complies with current regulations;
the socket can withstand the maximum load of the appliance,
which is indicated on the data plate located on the inside of
the door ( see Description of the appliance );
the power supply voltage falls within the values indicated on
the data plate on the inside of the door;
the socket is compatible with the plug of the appliance. If this
is not the case, ask an authorised technician to replace the
plug ( see Assistance ); do not use extension cables or multiple
sockets.
Once the appliance has been installed, the power supply
cable, the electrical plug and socket should remain accessible.
If the power supply cable is damaged, it must be replaced
by the manufacturer or its Technical Assistance Service in order
to prevent all potential hazards. (See Assistance)
The cable should not be bent or compressed.
The Company shall not be held responsible for any incidents
that occur if these regulations are not observed.
The special plastic elbow*
makes it easier to find the best
layout: fix the elbow to the wall
securely in order to prevent the
outlet hose from moving and
spilling the dirty water.
The part of the hose marked
with the letter A should be
between 40 and 100 cm above
the ground ( see figure ).
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add approximately 2 kg of salt ( see Rinse aid
and refined salt ). The water may overflow: this is normal and is
not a cause for concern. It is also normal that the LOW SALT*
indicator light continues to flash for a few cycles after the salt
has been loaded.
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order to
protect it from any condensation that may form.
width 44.5 cm
Dimensions
height 82 cm
depth 57 cm
Capacity
9 standard place-settings
Water supply
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure
4.3 psi – 145 psi
Power supply
See appliance data plate
voltage
Total absorbed
See appliance data plate
power
Fuse
See appliance data plate
This dishwasher conforms to
the following European
Community Directives:
-73/23/EEC dated 19/02/73
(Low Voltage) and subsequent
modifications
-89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent modifications
-97/17/EC (Labelling)
-2002/96/ CE (
Electrical and Electronic
Equipment WEEE)
* Only available in selected models.
Waste

Publicidad

Tabla de contenido
loading

Tabla de contenido