Teac UD-501 Manual Del Usuario página 11

Display (1)
When the POWER is turned ON
After the above messages appear, the input source will be
shown on the display.
When selecting an input source
The name of the input source is shown on the display
when you change input source.
Example: when OPT2 is selected
Input source name
Error indications
When the unit cannot lock the input signal, an "UNLOCK!"
error message blinks on the screen.
Example
c
Input source information display
During PCM audio input
When MODE DISP=OFF
Example
Signal type
When MODE DISP=ON, UPCONV=OFF, DF=OFF
Example
Upconverter is disabled
When MODE DISP=ON, UPCONV=ON, DF=SHARP
Example
Upconverter is enabled
When the input signal is locked at 352.8 kHz
Example
o When the input signal is locked at 352.8 kHz or 384 kHz,
the upconverter and PCM digital filter are bypassed, so
MODE DISP, UPCONV and DF will not be shown regard-
less of their settings.
Sampling frequency
Digital lter setting
Digital lter setting
EN
11