Playing back music on a computer (2)
Playing back audio files on a computer
1
Connect this unit to a computer using a
USB cable.
o Use a cable with a connector that matches that of
this unit.
2
Turn the computer power on.
o Confirm that the operating system has started
properly.
3
Press the POWER button to turn this unit
on.
14
USB cable
4
Turn the INPUT SELECTOR knob to select
"USB".
5
Start playback of an audio file on the
computer.
By maximizing the output volume from the computer
and adjusting the volume output from the stereo
amplifier, better sound quality can be achieved.
Minimize the stereo amplifier volume before begin-
ning playback. Then, gradually increase it.
When using headphones with this unit, turn the
PHONES LEVEL knob counterclockwise to minimize
the volume before starting playback. Then, gradually
increase it.
o The computer cannot control this unit, nor can this unit
control the computer.
o Do not do any of the following when playing back an
audio file via USB. Doing so could cause the computer
to malfunction. Always quit the music playback soft-
ware before doing any of the following.
u Unplugging the USB cable
u Turning this unit's power off
u Changing the current input selection
o When playing back an audio file via USB, computer
operation sounds will also be output. If you do not
want these sounds to be output, make appropriate set-
tings on the computer to turn them off.
o If you connect this unit with the computer or change
its input to "USB" after starting the music playback soft-
ware, audio files might not play back correctly. If this
should occur, restart the audio playback software or
restart the computer.