Euroflex SteamShark Manual De Instrucciones página 18

Using Your Steam Shark with Floor Brush
Step 1: Connect one of the extension tubes to the hand
grip on the flexible steam hose. To attach the
extension tubes one onto the other or onto the
hand grip, press the locking button ensuring
that it fits into the hole. (See illustrations.) To
disconnect, repeat the operation by pressing
the locking button and pulling the two sections
apart.
Security
button
Security
button
Tubos de Extensión
NOTE: Fit floor brush with the angle adapter on to the
extension tube.
Using Your Steam Shark with Floor Brush (cont.)
Step 2: If the angle adapter is not attached to the floor
brush, hold the brush with its bristles up in your
left hand. With the angle adapter pointing
downward, insert it into the hole in the back of
the brush, then turn the angle adapter 180°.
Step 3: Insert the electrical power cord into the wall
outlet. Heating time is approximately 3-5
minutes with cold water. Filling the steam
generator with hot water will shorten heat up
time.
Attaching a Towel to the Floor Brush
100% white terry cloth towel can be fitted on this brush so
as to absorb the dirt and protect delicate surfaces. It can
also be used on vertical washable surfaces following the
same procedure as for the floor.siguiendo el mismo
procedimiento que para el piso.
IMPORTANT: Please note that bristles may break through
thin towels. If you don't have thick enough towels, please
use 2 towels.
OPERATING INSTRUCTIONS (Cont.)
Handle
Fig. A
1. Prepare white terry cloth towel:as shown in Fig. A.
2. Ponga la escobilla sobre la toalla.
Fig. B
3. Fold the towel as shown in Fig. B
Fig. C
4. Fold the other side of the towel as shown in Fig. C.
Fig. D
5. Place the corner under the cloth holder as shown in
Fig. D.
18