Euroflex SteamShark Manual De Instrucciones página 20

Wood, Vinyl and Marble Floors
Use the floor brush with a terry cloth attached. Move the
brush across the floor as if you are mopping. When the
towel is soiled, you can turn the towel over or replace it
with a clean towel. If you are working on a very dirty area,
you can move the brush over the area slowly, several
times. If it is a wood floor, move fast to avoid heat or mois-
ture buildup in the wood. By cleaning with the towel over
the brush, you will not affect the shine on the floor.
To Strip Wax: Use floor brush for open areas; detail brush
for corners or tight areas - no towel, slow strokes. Work a
small area at a time - remove the emulsified wax from the
floor. When all of the wax has been stripped, immediately
clean the floor and brushes with water before residue has
a chance to harden on them. Go back over the stripped
area with the floor brush with a towel to remove any re-
maining residue before waxing.
To Clean Waxed Floors: Wrap clean towel around the
floor brush, brush quickly. This will cause the dirt to be
removed but not the wax.
Vinyl Floors: Do not allow heat to buildup in any kind of
vinyl, since it can soften it enough to affect its texture.
Work fast on vinyl.
Tile Floors: Use the detail attachment with the detail brush
attached to an extension. Have the floor brush with cloth
attached ready as well. Clean the grout between the tiles
with the detail brush. Remove the detail brush and attach
the floor brush, move the brush across the floor to clean
the tile and remove excess moisture and residue. For ar-
eas of tile that are very dirty, remove the towel and agitate
with the brush. Do not let the area dry before you wipe it
up.
USAGE SUGGESTION FOR STEAM SHARK
Spot Cleaning (Carpets)
Use the concentrator nozzle with or without the detail
brush. Move slowly over the soiled area, allowing the
steam to penetrate. Agitate with detail brush or clean towel.
Dab the spot with the towel (do not rub). Repeat as nec-
essary to remove stain. Vacuum only after the carpet has
completely dried. Always test color fastness of carpet in
an inconspicuous area before cleaning. If your Steamshark
fails to remove stubborn stains a commercially available
carpet shampoo may be required.
Do NOT add cleaning solutions, scented perfumes, oils
or any other chemicals to the water used in this appliance
as this may damage the unit or make it unsafe for use.
Upholstery
Use the floor brush attached directly to the hand grip with
a clean white terry cloth towel. Use fast, light strokes, avoid
getting the fabric wet. Be patient with stubborn spots; work
on a spot gently for no more than a minute at a time, then
wait five minutes for the area to dry and repeat. Use cir-
cular movements or back-and-forth and side-to-side move-
ments to get all sides of surface fibers. Finish with a brush-
ing in one direction that will give the fabric a uniform ap-
pearance.
CAUTION: Always determine the color-fastness of any
fabric-especially with reds or blues - by taking a clean,
moist, warm towel and gently rubbing a small area as far
down on the back or other out of the way place on the
furniture as possible. If color comes off on the towel, you
may need to have the piece dry cleaned.
20