Publicidad
Idiomas disponibles
Idiomas disponibles
Manual monitor activation(auto-on)
* With the monitor in standby:
· Press the «
· Press the «F» button to activate only the screen. You can also activate/
P
F
deactivate communication by pressing the «
In both cases, the screen and communication remain active for 60 se-
conds, after which they are disconnected automatically. During this time, it
is possible to open the door by pressing the «
Brightness ( ), contrast ( ) and colour ( ) control
* With the screen lit, press the corresponding buttons to make the desired
adjustments. There are eight cyclically selectable control levels.
P
F
Melody selection
* Press the « » button to enter melody selection mode (the lateral lighting
comes on intermittently in PLUS version).
Call from Outdoor Panel: Press the « » button sequentially to hear the
P
F
different melodies (up to 36). Press the « » button again to select the
current melody.
Doorbell call: The monitor has a characteristic melody for the doorbell (if
there is a pushbutton connected to the corresponding monitor terminals).
Volume control
* While in communication with the outdoor panel, press the «
conversation volume (there are four cyclically selectable volume levels).
While in melody selection, press the «
P
are five cyclically selectable volume levels).
F
Call to Guard Unit (depending on installation)
* In MDS installations with guard unit, press the door release button (
with the monitor on standby, to generate a call to the guard unit.
P
F
» button to activate the screen and set up communication.
» button to adjust the melody volume (there
» button.
» button.
» button to adjust the
ENGLISH
),
Publicidad
