Kremlin Rexson CYCLIX II Traducción Del Manual Original página 69

4. CONNECTION

GROUNDING
The motor is fitted with an earth cable. Connect the other end to a safe earth.
The foot of the elevator is fitted with a threaded rod. You can connect it to a safe
ground.

CONNECTION TO THE COMPRESSED AIR SUPPLY
Air fitting 1/4" G
Level of filtration required : 5 µm
Connect the installation to the compressed air network (maximum 6 bar / 87 psi).
Adjust the lubricator to get a flow of one drop / minute when high speed or constant operating.
Note :
The air supply to the agitator is via a hose fitted with a quick release fitting that can be connected to
the elevator on motoraccording to the working stage.

When you have to rise or lower the cover, the air hose must be connected to the elevator; there
is no air on the motor of the agitator.

When the air hose is connected to the agitator motor and is in operation, you cannot rise or
flower the cover.

FLUID CONNECTION
Suction rod
Return rod
KREMLIN REXSON
Install a filter and a lubricator on the air supply of the agitator.
To ensure a correct operating and an optimum working life of the
agitator, the supply air must be clean (without water), filtered and
 Install an FRL on the air supply of the agitator.
Elbow, model F 3/4 " G
Male 1/2 "
- 9 -
lubricated.
N° : 578.038.120-UK-1408