Sup Inflation And Deflation - Jimmy Styks Thresher Manual Del Propietário

INFLATION TROUBLE SHOOTING
SUP NOT INFLATING or AIR ESCAPING SUP WHILE INFLATING
Verify the valve pin is in the "UP" position. "UP" keeps air in. "DOWN" allows air out.
Verify the air hose is securely fastened to the air valve.
The air valve may be loose. Refer to "VALVE TIGHTENING" below.
Back-flow air pressure does not reach measureable levels until the paddleboard is
substantially inflated. If the pressure guage is not registering a value, the board may
still require more inflation until a pressure reading occurs.
Check for tears and/or cracks. This is best performed in water. Submerge the sup
and look for streams of air bubbles. If a large body of water is not available, try a
spray bottle filled with water and dish soap. Spray the board along the seams and
look for billowing soap bubbles. If a tear/hole is located, refer to "INFLATABLE SUP
REPAIRS" in this manual.
If none of these tips resolve the issue, contact us online through our live chat or
email at www.jimmystyks.com.
VALVE WRENCH
SUP INFL ATION AND D EFLATION
VALVE TIGHTENING
Occasionally, the valve on your inflatable SUP may become
loose. If the valve flange freely spins when opening the
valve cover or you detect air leaking from the valve area,
tightening may be required. Using the included valve
wrench, tighten valve in a clockwise motion until hand tight.
NEVER USE THE VALVE
WRENCH WHEN SUP
IS PRESSURIZED.
Q U E S T I O N S / C O M M E N T S :
1 - 8 0 0 - 3 7 0 - 0 7 4 5
11