Tangent EVO E5A Manual Del Usuario página 10

The rear panel of this speaker is equipped with an amplifier for driving the speakers.
This makes the speaker extremely flexible for use in many different places.
1. Input
This 3.5mm stereo jack input can be connected to either a line output signal or a pre
output signal. The input can be both a stereo or a mono signal.
You can connect your MP3 player to this input via the head phone output on the MP3
player. please notice that if a signal is not provided for more than 10 minutes, the
speaker will go into standby by it self. Once a signal is provided again, the speaker will
turn on again.
Note: Do not attempt to connect a speaker output to this connecter. It will damage the
speaker.
Output
2.
This 3.5mm stereo jack output is for connect another Tangent EVO E5A. It is also
possible to connect an active subwoofer to this output, if the bass level is not sufficient.
Please notice that the signal in this connecter will follow the signal in the input
connecter, when the "volume bypass" is set to ON.
Channel select
3.
When a stereo signal is provided to the EVO E5A, it is possible to choose whether the
speaker should play as a LEFT speaker, a RIGHT speaker or a MONO speaker.
If two EVO E5A are connected to you setup, the speaker you have placed on the right
side, should be set to RIGHT, and the left speaker should be set to LEFT, in order to
obtain the correct stereo perspective.
If only one speaker is connected this switch should be set to "MONO"
4. Volume bypass
This switch has two settings:
ON: When the switch is set to ON, the volume level of the EVO E5A will be set to
maximum level and the speaker cannot be remote controlled anymore. This should be
used, when the source connected to the speakers are controlling the volume, or the
volume is controlled by the speaker this speaker is connected to.
OFF: When the switch is set to OFF, the volume and standby function can be
controlled by the remote. Please notice that the volume level on the OUTPUT
connecter is also controlled by the remote, when the volume bypass switch is set to
OFF.
5. On/Off
Mains power switch.
AC input
6.
Check that all other connections have been made correctly before inserting the mains
plug into the wall socket. Then insert the plug into a suitable socket.
Note: If the unit is to be used abroad, you may need an adapter.
CAUTION: Do not turn on the power before all connections have been made correctly.
You might break your new unit. Check that all connections have been made correctly
before turning on the power. Check that the mains voltage is identical with the voltage
printed on the rear panel before turning on the power.
10