Tangent EVO E5A Manual Del Usuario página 12

Connecting a stereo setup
The illustration below shows how to setup two speakers to a source. The stereo setup
shown below is with volume control via the first speaker in the chain.
The source is connected to the line input on the speaker to the left. This can be a MP3
player via the headphone output, it can be a CD player or it can be a source with a pre
output (Volume controlled.)
The line output from the left speaker is connected directly to the line input on the right
speaker. The output on the right speaker can be used for e.g. a subwoofer or another
Tangent EVO E5A.
The settings of the switches on the rear panels should be as described below.
The left speaker: The channel select switch must be set to L (left) since it the speaker that
is physically placed on the left side. If the physical position is switched, the channel select
switches on the speakers should be switches as well. That means the channel select switch
should always be the same as the physical placement of the speaker.
The volume bypass switch should be set to OFF. This way you can control the volume via
the included remote.
12