sanindusa PLAN Instrucciones De Montage Y Manutencion página 42

//PRE–INSTALLATION INFO
Check contents:
Separate all parts from packaging and check each part with the pack contents section.
Make sure all parts are accounted for before discarding any packaging material. If any parts are missing,
do not attempt to install the electronic flush valve until you obtain the missing parts.
Warnings:
Do not install the system facing a mirror or any other electronic system operated by an
infra-red sensor.
To prevent reflection problems, it is recommended keep a minimum distance of 1.50 meters between the
flush valve and other objects.
Preparation for installation:
Flush water supply lines thoroughly before installing the flush valve. Do not allow dirt, Teflon tape or
metal particles to enter the flush valve.
All plumbing is to be installed in accordance with applicable codes and regulations.
Important:
For the optimal performance of this flush valve, the entire piping infrastructure from the main big
water-supply pipe down to the W.C. would have 1" diameter.
42//43