Manufacturer's Warranty; Indications Relatives À La Documentation; Explication Des Symboles; Avertissements - Hilti DGH 130 Manual De Instrucciones

Trouble or fault
The tool doesn't start.
The tool doesn't work.
The tool doesn't achieve full
power.
Elevated temperatures at the
gear housing.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 FCC statement (applicable in US) / IC statement (applicable in Canada)
The product complies with part 15 of the FCC Rules and RSS­210 of the IC.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti can restrict the user's right to operate the
device.
Français
1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
1.2

Explication des symboles

1.2.1

Avertissements

Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
10 Français
Possible cause
The carbon brushes are worn.
The tool has been overloaded.
The extension cord conductor
cross section (gauge) is inade-
quate.
Short braking interval.
Action to be taken
▶ Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
▶ Release the on/off switch and
then press it again. Then allow
the power tool to run under no
load for approx. 30 seconds.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Allow the device to run under no
load until it has cooled down.
2204297
*2204297*
Les termes de