Manufacturer's Warranty; Further Information - Hilti NURON GTB 6X-22 Manual De Instrucciones

9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
The product or battery gets
very hot.
Product does not develop full
power.
The motor has no braking
effect.
LEDs of the battery show
nothing
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
qr.hilti.com/manual/?id=2327538&id=2332260
This link is also to be found at the end of the documentation, in the form of a QR code.
26 English
Possible cause
Very low ambient temperature.
The retaining lug on the battery is
dirty.
Electrical fault
A battery with inadequate capacity
was used.
Battery is discharged.
Product is momentarily
overloaded.
Battery faulty.
technology, environment and recycling,
Action to be taken
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lug and
re-insert the battery.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Use a battery with adequate
capacity.
▶ Change the battery and charge
the empty battery.
▶ Switch the product off and then
on again.
▶ Contact Hilti Service.
follow this link:
2327538
*2327538*