Publicidad
PIPE ASSEMBLY
(Figure 1)
1. Take pipe assembly out of carton as shown. (Step 1)
2. Loosen Height Adjustment Nut turning counter clockwise. (Step 2)
3. Raise Extension Pipe. (Step 3)
4. Tighten Height Adjustment Nut turning clockwise. (Step 4)
Figure 1
Step 2
Step 1
STAND ASSEMBLY
PLACE BASE FLAT ON FLOOR
1. With a twisting motion, insert the end of the large diameter
pipe into hole in Base.Turning tube while pushing will assure
tube is fully seated in base
For Height Adjustment:
a.)Loosen Height Adjustment Nut.
b.)Raise or lower Extension Pipe to desired height.
c.)Tighten Height Adjustment Nut.
Extension Pipe
Height
Adjustment
Nut
Base
HEAD ASSEMBLY
1. Place Head Assembly with Collar onto Pipe Assembly.
2. Holding Extension Pipe firmly, twist Head Assembly downward
until seated on pipe.
Collar
Rev. J 1/08
MODEL 4CH63D/9119D
Extension
Pipe
Height
Adjustment
Nut
Step 3
(Figure 2)
Figure 2
(Figure 3)
Head Assembly
Extension Pipe
Figure 3
BLADE & GRILL ASSEMBLY
1. Tilt Fan Head back. Put Rear Grill on Motor.
Motor
Step 4
2. Align tab on Plastic Rear Grill with groove on top of front
Motor cover. (Figure 4A)
3. Fully seat Rear Grill and secure with Plastic Nut turning Clock-
wise. Slide Blade onto Motor Shaft (Align groove on blade hub
with pin on motor shaft). (Figure 4B)
4. To secure Blade, screw Spinner onto Shaft
Counter Clockwise until tight on Blade hub.
5. With fan head in upright position, align
Ornament on Front Grill so it is horizontal
and right side up. By starting with the top
of the grill and working down, insert Snaps
on Rear Grill through Slots in Front Grill. (Figure 5)
Ornament
Snap
Figure 5
2
(Figure 4)
Rear Grill
Plastic
Nut
Rear
Grill
Motor
Figure 4A
Pin
Groove
Figure 4B
Slots
Snap
Blade
Spinner
Figure 4
Slots
2081044
Publicidad
