The First Wash Cycle - Ariston WDL 862 Instrucciones De Uso

As the colours of the wires in the lead may not correspond
GB
with the coloured markings identifying the terminals in your
plug, proceed as follows:
Connect Green & Yellow wire to terminal marked E or
or coloured Green or Green & Yellow.
Connect Brown wire to terminal marked L or coloured Red.
Connect Blue wire to terminal marked N or coloured Black.
If a 13 amp plug (BS 1363) is used it must be fitted with a
13 amp fuse, either in the plug or adaptor or at the distri-
bution board.
If you are in any doubt regarding the electrical supply to
your machine, consult a qualified electrician before use.
How to connect an alternative plug:
The wires in this mains lead are coloured in accordance
with the following code:
BLUE
BROWN
GREEN & YELLOW
GREEN &
YELLOW
13 ampere fuse
BROWN
CROSS-BAR
BLUE
CORD GRIP
Disposing of the appliance:
When disposing of the appliance please remove the plug
by cutting the mains cable as close as possible to the plug
body and dispose of it as described on the previous page.
!
The washer-dryer should not be installed in an outdoor
environment, not even where the area is sheltered, becau-
se it may be very dangerous to leave it exposed to damp,
rain and thunderstorms.
!
When the washer-dryer is installed, the mains socket
must be within easy reach.
!
Do not use extensions or multiple sockets.
!
The power supply cable must never be bent or dange-
rously compressed.
!
The power supply cable must only be replaced by an
authorised serviceman.
Warning! The company denies all liability if and when these
norms are not respected.
4
All manuals and user guides at all-guides.com
NEUTRAL (N)
LIVE (L)
EARTH (E)

The first wash cycle

Once the appliance has been installed, and before you use
it for the first time, run a wash cycle with detergent and no
laundry, using the programme "Auto Clean" (see "Cleaning
the washer-dryer").