Functioning Anomalies - Apach ASM32F 2S 3PH Instrucciones Originales

USE OF THE 2 SPEED MACHINE
The machines with three-phase motor can be produced with the second speed.
To start these machines, proceed as follows:
1. Start the mixer as previously described in the points 1, 2, 3;
2. Select the desired speed by turning the selector knob to 1 or 2;
3. Once the set time is over, the timer stops the machine.
4. Press the "0" button to turn off the machine.
USE OT THE INVERTER MACHINE
1. Start the mixer as previously described in the points 1, 2, 3;
2. Select the percentage speed by turning the knob of the inverter from
0% = 1st speed to 100% = 2
"100%" speed increases from minimum to maximum. In the opposite
direction, the speed decreases;
3. Once the set time is over, the timer stops the machine.
4. Press the "0" button to turn off the machine.

FUNCTIONING ANOMALIES

PROBLEM
The machine does not start
The spiral is not constant in the
rotation
The machine stops while it is
operating
23
nd speed; Turning the knob from "0%" to
CAUSES
Lack of electric current
The stop button is locked
The protection grid and / or the lid
are raised, or the bowl is not well
positioned.
The timer is in position 0
The chain is loose
the fuse does not work
SOLUTIONS
Check the general switch, the plug
and the power cord
Press the green button
Properly lower both the protection
grid and the cover and reposition the
bowl
Set the timer from 1 to 30 minutes or
in manual mode
Tighten the chain
Replace the fuse with another, with
the same characteristics