Protection Against Magnesium Anode Oxidation; Periodic Maintenance - Rointe Venice Instrucciones

• Position I (summer mode): The thermostat is in economical mode for low water temperature and
low power consumption. This mode is suitable when high water temperature is not necessary.
• Position II (winter mode): The thermostat is in optimal mode, with higher water temperature values.
This mode is suitable for when high water temperatures are necessary.
e
• Position (energy saving mode): During this operating mode the water reaches a temperature of
approximately 60ºC for reduced heat loss.
• Position III (maximum mode): The thermostat is set in maximum operating mode, with very high
values of energy consumption and with maximum water temperature levels (around 70ºC). This is the
most suitable mode when a large volume of water with a pleasant temperature is needed.

6. PROTECTION AGAINST MAGNESIUM ANODE OXIDATION

The magnesium anode protects the inner surface of the water tank against corrosion.
The magnesium anode will deteriorate over time and is subject to periodic inspections. Rointe/the
manufacturer recommends a periodic inspection of the magnesium anode by an authorised technician and
if appropriate, during the periodic prophylaxis of the water heater.
To replace the magnesium anode, please contact the Rointe Technical Service on 0203 321 5929.

7. PERIODIC MAINTENANCE

Under normal operating conditions, and with a high temperature on the surface of the electrical resistance,
lime scale deposits can often occur. This worsens the exchange of heat between the resistance and the water,
causing the resistance to overheat along with typical noises of boiling water. The thermostat will turn on and
off more frequently. It is possible to activate the protection mode to avoid overheating. Because of this, the
Rointe/manufacturer recommend preventive maintenance every two years by an authorised installer from
the Rointe Technical Service (please call 0203 321 5929).
This maintenance should include cleaning and inspection of the anode, which should be replaced when
necessary.
To clean the appliance, use a damp cloth. Do not use abrasive cleansers or those containing solvents. Do not
pour water over the water heater.
ROINTE reserves the right to modify the characteristics and specifications of its products without prior notice.
ROINTE is not responsible for any consequences arising should the instructions contained in this manual not
be followed.
9
EN