Stagnoli ACHILLES-1200 230V Manual De Instrucciones página 7

Istruzioni Instructions Anleitungen instrucciones Инструкции Instrukcja
Attention!
This manual is for qualified installers only and not for the end user. It is the installer's job
•
to explain to the user how the automatism works, about possible hazards related to it
and the need for periodical maintenance.
Installation must be carried out by qualified personnel only, in compliance with
•
current standards concerning automatic closing mechanisms; particularly the
installation has to comply with the 89/392 directive and the EN 12453 and EN12445
regulation.
ACHILLES is made specifically to control the automation of sliding gates and therefore
•
it is forbidden to use it for any other purposes or improperly.
Use original components only. Stagnoli is not liable for damages if any other
•
components are used.
Make sure that the gate structure is solid and suitable to be motorised.
•
Make certain that when the gate is moving there are no points of friction and there is
•
no chance of it derailing.
Make absolutely certain the power is disconnected before carrying out any work on
•
the device.
Connect the power lead only to supply lines with adequate electrical protection; more
•
specifically mount a device to guarantee disconnection of all phases from the mains
that has a distance of at least 3.5 mm between the contacts.
Be particularly careful when evaluating the safety devices to install and their location.
•
Always install an emergency stop device that will cut power off in the case of
necessity.
Only qualified personnel must be allowed to service the unit.
•
The irreversibility of the gearmotor avoids the installation of electronic locks and in
•
case of black-out, the manual key release allows easy opening and closing of the
gate.
7