TRAPP DM 50 Manual De Instrucciones página 27

www.trapp.com.br
Additional Safety and Operation Instructions
Make sure the voltage of the power source is the
 
same of that of the equipment.
Carefully read instructions and get familiar with the
 
controls and proper use of the equipment.
Remember that the operator or user is responsible
 
for any accident or damage involving people or
their properties.
Do not operate the equipment barefooted or with
 
sandals.
Always wear adequate shoes and pants, goggles,
 
gloves and ear plugs.
Avoid operating the equipment in humid places.
 
Use the equipment in a well lit environment.
 
Before inserting the corncob, start the motor and
 
wait until it reaches maximum revolution.
Do not introduce anything in the equipment with
 
the motor off.
Do not use the equipment during periods of power
 
supply failure.
If the equipment starts to vibrate, turn it off and
 
immediately unplug it. Check the cause of the
vibration as it indicates that the equipment needs
adjustment or repair.
Attention!
Frequently check if all screws are well
tightened.
Check the status of the power supply cord. Never
 
fix it with insulating tape.
Never use a water jet to clean the equipment; use a
 
cloth soaked in neutral detergent.
Never operate the equipment without the belt
 
protection guard.
Attention!
When the equipment is operating, do not
insert your hand into the feeding funnel, the
output chute, and into the straw output.
Attention!
Whenever cleaning or servicing, make sure
the equipment is off, and the rotor stopped.
Remember that the rotor keeps moving for
some seconds.
27