Maintenance Instructions - TRAPP DM 50 Manual De Instrucciones

www.trapp.com.br
Start the equipment.
 
Place a container in the grain output chute.
 
Insert the corncob in the feeding funnel.
 
Take care not to overload the motor.
 
For being an equipment constantly
exposed to the vibration promoted by
the impact of threshed corncob, it is
natural that screws get loose with time.
Therefore, periodically check screws,
and if necessary retighten them. Be
careful, however, not to strip the thread.
Using the Equipment with Combustion Motor
Important recommendations
Never start or leave the engine running in a
 
confided area or without proper ventilation. The gas
from the exhaust contains carbon monoxide which
is inodorous and lethal.
Do not use oil mixed with gasoline in threshers
 
equipped with four-cycle motors.
Before operating, make sure the crankcase oil level
 
is right.
The motor leaves factory with neither oil nor fuel.
 
Operation

Maintenance Instructions

Attention!
Use dry corn only.
 
The cobs and straw are exited by the rear part
 
of the equipment.
The motor may burn due to overload if
 
excessive material is fed.
Attention!
Always turn off the equipment and unplug it
before servicing or cleaning
Never service the equipment with the motor on.
 
For any kind of maintenance the spark plug must
 
be disconnected.
Warm the motor up before operating the
 
equipment.
Caution: gasoline is highly flammable.
 
Turn off the motor before removing the fuel cap.
 
Do not add gasoline when the motor is running or
 
still hot.
Before filling the tank, allow the motor to cool
 
down for approximately two minutes.
31