Mopar 82212123AB Instrucciones De Montaje página 6

6
11. Install the two plastic snap­in nuts (1) to the door.
12. Position the latch assembly (latch, presenter, links,
harness and inside handle) (6) to the door (1).
NOTE: The wiring harness (2) will need be fed through
the access hole nearest the latch area.
13. Route the wiring harness (2) along the upper portion
of the door (1) and down the side. Install the wiring
harness push pin retainers into the door assembly.
NOTE: If vehicle is equipped with power win­
dows/locks, the harness connector will need to be
removed and replaced.
14. Position and install the inside release handle screws
(4) to the door (1).
Tighten the screws (4) to 5 N.m (44 in. lbs.).
15. Install the plug (8) to the door (1).
Mar 30, 2009 K6860780 Rev.1