Alarm Setting; Display Brightness Control - Trevi DME 3228 Guia Del Usuario

Hold "CLOCK " button to enter clock setting mode. Using "
in sequence: 12/24hr format > Hr > Min > Yr > D/M or M/D format > Month > Date > EXIT
HOME TIME, WORLD (ZONE) TIME
Hold "ZONE" to enter world (zone) time setting mode. Press "
Press "ZONE" to confirm each setting.
Press "ZONE" button to toggle between home time and world (zone) time. "ZONE" icon appears when world (zone) time is selected.
When zone time is not used, set zone time to "0" .

ALARM SETTING

Press "ALARM" to show alarm time and "AL." icon will appear. Press again to enable or disable the alarm. Bell icon "
alarm is enabled.
Hold "ALARM" to enter alarm time setting mode. Press "
setting.
SNOOZE & BACKLIGHT
When alarm is going off, press SNOOZE/ LIGHT to trigger snooze alarm and "Zz" icon will appear. To stop alarm for one day, press
"ALARM" key. Press SNOOZE/LIGHT for an extended backlight if adapter is not connected.

DISPLAY BRIGHTNESS CONTROL

Select display brightness mode with the slide switch on the back casing.
- AUTO:
Display brightness is adjusted automatically according to the surrounding brightness detected by the light sensor located on the left
of the Snooze/Light button. In a bright environment, display brightness will increase. As the environment turns dark, display
brightness will reduce.
(Note: Auto mode is recommended for power saving, display lifetime and convenient purpose)
(Important: Avoid having obstacle above the light sensor window for an accurate light sensing result. Otherwise the display will turn
dim even in bright environment)
P_14 P_14 P_14
P_14 P_14
"or " " to adjust and "CLOCK" to confirm, the following values can be set
"or " " to enter the desired hour offset value from –12 to +12 hours.
"or " " to enter the desired Hr/Min values and press "ALARM" to confirm
DME 3228 DME 3228
DME 3228 METEO STATION DME 3228 DME 3228
" appears when
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH