Makita BBC300L Manual De Instrucciones página 10

010767
Fit the shoulder harness as shown and hang the
machine firmly on your right side so that the barrier is
always ahead of you.
Attachment of shoulder harness
010816
Hang the shoulder harness on your left shoulder with
putting your head and right arm though it. Buckle it to the
hook unit until a click is heard. Make sure that it cannot
be taken off with pulling it off. Hang the machine as
shown.
Adjust the strap length so that the cutter blade will be
kept parallel with the ground at the level of 10 to 30 cm
(4" to 12") above the ground.
Detachment
010817
In case of emergency, press the emergency detachment
lever strongly.
WARNING:
Be extremely careful to maintain control of the
•
machine at this time. Do not allow the machine
to be deflected toward you or anyone in the
work vicinity. Failure to do so could result in
serious injury.
MAINTENANCE
CAUTION:
Always be sure that the equipment is switched off
•
and the battery cartridge is removed before
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Supply of grease to gear case
010812
Supply grease (Shell Alvania 2 or equivalent) to the gear
case through the grease hole every 30 hours. (Genuine
Makita grease may be purchased from your Makita
dealer.)
Replacing the nylon cord
WARNING:
Release the switch trigger and remove the battery
•
pack before replacing nylon cord.
Make sure that the cover of the nylon cutting head
•
is secured to the housing properly as described
below. Failure to do so may make it fly apart and
cause serious injury.
Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
•
nylon line. Never use metal wire, rope, or the like.
2
3
010772
Press on the housing latches inward to lift off the cover,
then take the spool out and remove the remaining nylon
10
1. Gear case
2. Grease hole
1
2
1. Cover
1
2. Latches
3. Press
3