Raymarine RS130 GPS Manual De Instrucciones página 7

1. Securely attach the pole mount base to a suitable
pole.
2. Pass the cable and connector through either:
• 2a) the center of the pole mount bracket and the
pole; or
• 2b) the cable exit hole alongside the center hole.
3. Attach the connector securely to the plug in the
base of the unit.
4. Secure the receiver to the pole mount base using
the screws provided.
8
Flush mounting the GPS receiver
3
2
1
2a
2b
4
D12048-2
1. Use the supplied mounting template to mark the 2
fixing holes and the center hole.
2. Drill the holes using the drill sizes shown on the
supplied template.
3. Screw the 2 fixing studs into the underside of the
receiver unit.
4. Place the waterproof gasket into position on the
underside of the receiver.
5. Attach the connector securely to the plug in the base
of the unit and pass the cable through the center
hole on the mounting surface.
6. Carefully position the receiver so that the mounting
studs pass through the holes in the mounting
surface.
7. Secure the receiver to the mounting surface using
the two thumb nuts (these should be hand-tight
only).
Rail mounting the GPS receiver
1. Obtain a suitable rail mounting bracket from your
dealer. It must have a 1 inch 14 TPI thread.
2. Secure the rail mounting bracket to the GPS
receiver.
3. Secure the bracket to a suitable rail.
4. Route the cable along the rail and secure with cable
ties.
GPS receiver SeaTalkng connection
Secure the SeaTalk ng plug into the GPS receiver
connector.
1. Rotate collar to the UNLOCKED position.
1
D12047-2
2. Ensure cable end connector is correctly orientated,
then fully insert.
3. Rotate collar clockwise until it snaps into the
LOCKED position.
3
2
D12049-2
RS130 GPS