Power Saving - Climadiff DUOVINO/1 Manual De Instrucciones

Unpack the appliance and visually check that it is not damaged. Do not
•
connect a damaged appliance. Inform your retailer or point of sale of any
damage. In such a case, keep the packaging.
It is recommended that the appliance be allowed to settle for at least
•
4 hours before connecting the electrical power supply, so that the
compressor fluid feed is correct.
Proper air circulation is necessary to avoid overheating. To ensure
•
sufficient ventilation, observe the installation recommendations provided.
In order to avoid fire risk, wherever possible, ensure that the appliance is
•
not in contact with walls or with any hot element (compressor, condenser).
Observe the installation recommendations.
The appliance should not be placed close to radiators or cooking hot plates
•
or gas rings.
Check that electrical sockets remain accessible when the appliance
•
is installed.
The appliance has to be installed in a room where ambient
•
temperature is between 16 and 32°C. Over or under this recommended
temperature range, performances may be affected.
This appliance is not intended to be used in an unheated room
•
(garage...), you have to place in an ambient room.
This product is designed for maximum cooling to 15 ° C below
•
ambient temperature.

POWER SAVING

To limit the electricity consumption of your appliance:
• Install it in an appropriate place (see "Installing your appliance").
• Leave the doors open as little time as possible.
•To ensure that the appliance operates properly, clean the condenser
regularly (see "Routine servicing of your appliance").
• Regularly inspect the door seals and ensure that they are still closing
properly. If this is not the case, contact your after-sales service.
21