Troubleshooting - Proline GR800 Manual De Instrucciones

Storage
• Drain any water in the appliance before completely
operating the appliance on fan only mode for a few hours,
to thoroughly dry the inside.
• Clean the filter.
• Store the power cord as shown.
• Remove the batteries from the remote control and place
the remote control in the storage area at the rear of the
appliance.
• Place the appliance in a dry place.
TROUBLESHOOTING
Never try to repair or dismantle the air conditioner yourself.
Problem
The air conditioner does
not function.
The air conditioner
seems to have little
cooling effect.
The air conditioner is
noisy.
The remote control does
not function.
Possible Cause
No power supply.
"H8" is shown on the display.
In direct sunlight.
Windows or doors open, many people
or a heat source in the room.
Dirty filter.
Air inlet or air outlet blocked.
The room temperature is lower than the
selected temperature.
The appliance stands uneven.
Distance too great.
The remote control signal is not
detected by the control panel.
The batteries are drained.
Connect to a functioning outlet
and switch on.
Empty the internal water tank.
Close curtains.
Close doors and windows,
remove the heat sources, and
place an extra air conditioner.
Clean the filter.
Remove the blockage.
Change temperature selection.
Place the appliance on an even,
solid surface (less vibrations).
Make sure the remote control is
correctly aimed at the control
panel.
Replace the batteries.
14
Possible Solution