General Information - Singing rock DSDplus Manual Del Usuario

Figure 6: HAULING AND PROGRESS CAPTURE
Lead the free end of the rope through the groove at the head of the brake
lever and connect it with a progress capture to the working end of the rope
(fig. 6). In working environments always follow progress with a safety rope.

GENERAL INFORMATION

Regular examination:
• Do not hesitate to retire the device if it shows signs of wear (for rope
abrasion see indicator on the pivoting pulley) or after a major fall or a
major impact. They could cause internal or invisible damage that may
significantly weaken its strength. In case of uncertainty treat the device
as damaged or consult SINGING ROCK. Additionally treat the device
as faulty if any of the forth mentioned applies: absence or illegibility
of markings; absence of any elements affecting the equipment form
and function; evidence of defects in or damage to hardware elements
including but not limited to cracks, sharp edges, deformation, absence of
parts, corrosion, and other forms of alteration; any other condition that
calls to question the suitability of the equipment for its intended purpose.
• Regular periodical inspections must be carried out by a competent
person at least once a year. For this purpose an inspection record should
be established (see the backside of these instructions). Furthermore we
would sincerely recommend one set of equipment is used by one person
only as its history of use is best traced and understood in this way.
• Before each use it is obligatory to check the descender and verify that all
its components (handle, jamming cleat, flanges) are faultless and in good
working condition.
PACKING, STORAGE, MAINTENANCE AND CLEANING
Each product is packed with its INSTRUCTIONS FOR USE. Proper main-
tenance and storage are imperative to ensure correct functioning of the
product (as well as all your equipment) and thus your safety.
Clean the product with a brush under running cold water of domestic
supply. If the stains persist, clean it in warm water (maximum 30 °C) with
ordinary soap. Then rinse thoroughly, wipe it with a towel and dry naturally
in a shaded ventilated place away from sources of heat.
If needed, lube sparingly the moving joints of the jamming cleat and handle
with silicon based oil.
TEMPERATURES
While it is allowed to use this product within the temperature range from
-20 °C to +60 °C, it is advisable to stock it in a dry place at room temperature.
LIFETIME
Lifetime is set by the date of production and is theoretically unlimited.
Service time starts with the date of first use and depends on frequency and
mode of application, on environment where it is used (e.g. marine, cave,
corrosive atmosphere), and on mechanical wear and damage. It is therefore
very difficult to determine the expected service time of a particular device.