Olympia PS 710.3 CCD Manual De Instrucciones página 20

8 Clearing Material Jams
If too much material (paper, CDs, credit cards) is fed to the cutting mechanism at one
time, the material jams. The OVERLOAD warning lamp lights up and an acoustic alarm
is issued. The motor switches to reverse and it should be possible for the user to pull the
the paper directly out of the infeed, using a little force if necessary. The motor then stops.
If there is still material in the infeed, proceed as follows:
Press and hold the REV button and allow the material to be ejected out of the
machine in reverse mode.
Press and hold the FWD button and allow the material to be removed from the
machine in forward mode.
If necessary, remove any residual material manually from the automatic paper infeed.
The machine then reverts to AUTO mode.
Reduce the quantity of material being fed into the shredder.
8.1 REV button (reverse operation)
Press and hold the REV button so that the cutting mechanism runs in reverse and the
material is released.
8.2 FWD button (forward operation)
Press and hold the FWD button to run the cutting mechanism forwards to shred any
residual material left in the infeed and remove it from the cutting mechanism.
Note: The FWD button is used after clearing a material jam to start the cutting
mechanism running without feeding any new material through the respec-
tive infeed.
8.3 Removing residual paper from the automatic paper
infeed
10. Set the On/Off switch to its OFF position and disconnect the power plug from the
power socket.
11. Unlock the automatic paper infeed by setting the safety knob to its OPEN position.
12. Hinge up the safety guard on the automatic paper infeed.
13. Remove any jammed paper carefully from the cutting mechanism using a suitable
tool.
14. Hinge the safety guard on the automatic paper infeed back down.
15. Lock the safety guard of the automatic paper infeed by sliding the safety knob to its
LOCK position.
16. Reconnect the power plug in the power socket and set the On/Off switch to ON.
20